Experimental Flotation Machine
More
Experimental Flotation Machine
Laboratory 39 litres of flotation machine suitable for laboratory planktonic method for mineral choose don't use. The flotation machine is the number of continuous set up for continuous flotation machine, slot number is odd, since the two tank to the ten tank, according to user requirements can be left or right type flotation machine.
The description of the structure:
39 liters of flotation machine for laboratory, is of impeller mechanical flotation machine, consists of the following main parts: (1), body parts, with steel plate welding manufacturing groove 1, wherein using impeller stirring the pulp to breath; to adjust the slot level and scraped froth layer thickness, the two slot wall plate into a middle groove 15, wherein the liquid level regulator is installed in the groove cover 5, 14 above the mounting hole plate 17, used to prevent the influence of pulp of chaos movement to the bubble area, but also can prevent the gangue is mechanical to concentrate. And there are 6 in the tank lining basin is provided, to prevent wear groove bottom, lining basin can be replaced, the tank bottom and decorated with row ore mouth 8, cleaning water use. The pulp flow through the overflow wainscot mouth into the middle groove 15 and tail groove 3, the lower part of the middle groove and groove wall of the lower cover 14 of the catheter into the next slot, so you can continue to flow through the slot number of flotation machine, all from the feed chute, 3 into 1, the tailings discharge 8 discharge, the lower part of the body before and after the mine inlet 16, facilitate the change process. (2), the system is installed in the center of flotation tank position, leaf upward into the disc impeller arranged 9, fixed at the lower end of the impeller shaft 10 around the vertical shaft tube 12, pipe is positioned in the pulp stone and foam layer, supported at the lower end cover 14, when the impeller rotates, along the vertical tube 12 can absorb a lot of free air, in the cover 14 is fixed under the protective plate 4, between the protective plate and the impeller gap size and the amount of air inhaled, the largest gap is not more than 3 mm, the gap is too large, the replacement of worn protective plate or the appropriate adjustments. On the 12 hole for vertical circulating pulp, and pulp with good air mixing together, the impeller shaft is installed in the bearing shell of the rolling shaft 11 rotation, the bearing shell is installed on the cross beam 7 is fixed on the top of the shaft, pulley, 18 switch on the motor rotate through the triangle belt, tension adjustment with three angle the nut, by 19 to achieve.
Inquiry DaiWo
If you are interested in these products, please leave your message，then，the relevent staff will contact you quickly . (Note: Please fill in your correct information)! Please send all your requests and proposals to sales@daiwomining.com.
